Using The Router Mode - Zoom Wireless-N User Manual

Using the Router Mode

This chapter explains how to setup your Wireless-N 4-port Router in Router Mode.
Most users will select this mode. In Router Mode the Wireless-N 4-port Router
typically connects to a broadband modem such as a Cable or ADSL modem and
becomes the center of a wired and/or wireless network.
Installing the Hardware
1
Place the Wireless-N 4-port Router near a computer to be used for setup. This computer needs an
Ethernet (LAN) port.
2
Turn off the computer.
Antenna
Ethernet ports
3
Attach the antenna to the Router if the antenna isn't already attached. (Remove the antenna from the
package. Place the end of the detachable antenna on the open antenna connection port and rotate the
antenna clockwise by hand until it no longer turns easily. It may take many turns before the antenna is
completely connected. Move the antenna into a vertical orientation. The antenna should snap into
place.)
4
Connect one end of the supplied Ethernet cable to the computer's Ethernet port and the other end to
any of the Wireless-N 4-port Router's Ethernet (LAN) ports.
Note: If you are using a Cable or ADSL modem to access the Internet, unplug that Ethernet cable
from your computer and plug it into the Router's WAN port. Then connect one end of the supplied
6
Wan port
Power Jack
Reset Button
Wireless-N 4-port Router User Manual
2