Wpa2 Auto-Personal; Wps Settings - Zoom 4402 User Manual

6
Click Apply.

WPA2 Auto-Personal

To configure WPA2 Auto-Personal settings, follow the
instructions below:
1
In the Zoom Configuration software, go to the Advanced:
Wireless Settings Tab and select Basic Settings.
2
In the Authentication Method menu, select WPA2 Auto-
Personal.
3
Create a WPA Pre-Shared Key of 8 or more characters and
enter it in the corresponding text box.
4
Click Apply.

WPS Settings

You can configure WPS using any of the following 4 methods.
Where the instructions are for configuring one device, you will
need to repeat the process for additional devices.
External WPS pushbutton: Press the WPS pushbutton on the
back panel of the router. Within 2 minutes, press the WPS
button on the client device (either a physical pushbutton on the
device or a button in the client's software page). The access
point will now begin accepting WPS connections. (If security has
not been set on the access point, a random SSID and WPA key
will be used.)
Enable WPS through Software: This is the same as pressing
the WPS button on the unit. Log in to the Zoom Configuration
screen (following the instructions in Step 2 of Ch 1). Click on
Advanced on the top menu. Then click the Wireless Settings
tab. On the left side pane, click on WPS. The WPS page opens.
Under Enable WPS check that it says Enabled (the default is set
to Enabled). If it shows Disabled, click on Enable. Within 2
minutes, press the WPS button on the client device (either a
physical pushbutton on the device or a button in the client's
software page). The access point will now begin accepting WPS
connections.
AP PIN code: Log in to the Zoom Configuration screen
(following the instructions in Step 2). Click on Advanced on the
top menu. Then click the Wireless Settings tab. On the left side
27