Connecting To A Wall-Mounted Telephone Jack - Cisco LRE CPE Hardware Installation Manual

Chapter 2 Installation

Connecting to a Wall-Mounted Telephone Jack

Step 1
Caution
Caution
Step 2
78-11469-04
The CPE connects to a Catalyst LRE switch through the telephone wiring of a
building. Follow these steps to connect the CPE to an LRE switch:
Connect one end of a telephone cord (not included) to the WALL port of the CPE.
(See Figure 2-9.)
To reduce the risk of fire, use only number 26 American Wire Gauge (AWG) or
larger telephone cable.
Always disconnect all telephone lines from the wall outlet before servicing or
disassembling this equipment.
Figure 2-9 Connecting to a WALL port
P W R
E N E T
W A L L P
We recommend using a telephone cable that has a three-pair, rollover
Note
configuration.
Connect the other end of the telephone cord to the wall telephone jack.
Connecting to a Wall-Mounted Telephone Jack
H O N E
Cisco LRE CPE Hardware Installation Guide
2-23