Connecting To A 10/100 Port - Cisco LRE CPE Hardware Installation Manual

Chapter 2 Installation

Connecting to a 10/100 Port

Note
Note
Step 1
Note
78-11469-04
The LRE CPE 10/100 ports configure themselves to operate at the speed of the
attached devices. Connecting devices that do not autonegotiate or that have had
speed and duplex parameters manually set can reduce performance or result in no
linkage.
If the attached ports do not support autonegotiation, you can explicitly set the
speed and duplex parameters.
The LRE CPE 10/100 ports are configured through a Catalyst LRE switch. Refer
to the switch hardware installation guide and the switch software configuration
guide for your switch model for more information.
The Cisco 575 LRE CPE and Cisco 576 LRE 997 CPE have only one 10/100 port.
Follow these steps to connect to 10BASE-T and 100BASE-T devices:
Connect a straight-through Category 5 cable to the ENET port on the Cisco 575
LRE CPE or Cisco 576 LRE 997 CPE. Connect a straight-through Category 5
cable to one of the ETH1 through ETH4 ports on the Cisco 585 LRE CPE. (See
Figure 2-7.)
Ethernet cables are not included with the Cisco 585 LRE CPE.
Figure 2-7 Connecting to a 10/100 LRE Port
P W R
E N E T
W A L L P
H O N E
Cisco LRE CPE Hardware Installation Guide
Connecting to a 10/100 Port
2-21