Assembly; Remove The Generator From The Shipping Carton; Install The Wheel Kit; Install The Support Leg - Champion PORTABLE GENERATOR Owner's Manual And Operating Instructions

Assembly

Assembly
Your generator requires some assembly.
This unit ships from our factory without oil.
It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the
assembly of your generator, call our help
line at 1-877-338-0999. Please have your
serial number and model number available.
Remove the Generator from
the Shipping Carton
1. Set the shipping carton on a solid, flat
surface.
2. Remove everything from the carton
except the generator.
3. Carefully cut each corner of the box
from top to bottom. Fold each side flat
on the ground to provide a surface area
to install the wheel kit and support leg.

Install the Wheel Kit

CAUTION
The wheel kit is not intended for over-the-road
use.
You will need the following tools to install
the wheel kit:
17 mm wrench OR adjustable
wrench (not included)
Socket wrench with a 16 mm socket
Pliers (not included)
1. Before adding fuel and oil, tip the
generator on it's side.
2. Slide the M10x120 wheel bolt through
the washer, sleeve and wheel.
3. Slide the bolt through the mount point
on the frame.
4. Fasten securely with the M10 nut.
5. Repeat steps 2-4 to attach the second
wheel.
8

Install the Support Leg

1. Attach the support leg to the generator
frame with cap screws (M8x16) and lock
nuts (M8).
2. Tip the generator slowly so that it rests
on the wheels and support leg.
Rev 41152-20100413 E