Messages - Jura IMPRESSA 401 Instructions For Use Manual

18. Messages

Display
Fault
Fault
Cause
220 draw-offs or 180 rinses have been
The display does not go off even though
the machine has been cleaned
The machine must be de-scaled
The display does not go off even though
the machine has been de-scaled
Temperature too low (after transport)
Fault
Rinsing is necessary
The coffee grounds container is full
The display does not go off even though the
grounds container has been emptied
The display appears after only a
few cups
Drip tray missing
Action
Clean as described in donepoint 14
Run cleaning programme again;
this time, do not add a cleaning tablet
De-scale as described in point 15
Run de-scaling programme again, only this time
with water and not with de-scaling agent
– switch machine off
– leave to stand at room temperature for 2 hours
– switch machine on
– Switch the machine off
– disconnect from mains
– switch the machine on
Press the rinse key
Remove the drip tray,
empty the grounds container,
replace the drip tray
The tray was out of the machine for less than
8 sec. in emptying. The drip tray is to be removed
for about 10 seconds and replaced.
Leave the machine on while the grounds
container is being emptied. Resetting the
counter only takes place with the machine on
Remove and empty tray, replace properly
E
17