Drawing Off Steam; Return To Readiness For Coffee; Drawing Off Hot Water; Switching Off The Machine - Jura IMPRESSA 401 Instructions For Use Manual

Never use water-soluble instant coffee or express coffee. We
recommend that you only use powder from freshly ground
coffee beans or pre-ground, vacuum-packed coffee. Never
put more than 2 portions of powder in. The filling shaft is
not a storage place.
If the drawing-off key
can be cancelled again by pressing a drawing-off key. Your
machine rinses.

10. Drawing off steam

The steam can be used to heat liquids and also to froth up milk for
cappuccino. Please ensure that the frothing nozzle (19) is pushed
upwards when heating liquids. When frothing liquids, push the
frothing nozzle downwards (Fig. 4).
Place a cup under the pivoting nozzle for hot water/steam (18).
Press the selector key . As soon as the control lamp lights up,
you can draw off steam.
Immerse the frothing nozzle (19) into the milk to be frothed or
the liquid to be heated.
Turn the selector key coffee or hot water/steam (17) to the po-
sition .
To end the draw-off of steam, put the selector key coffee or hot
water/steam (17) back to position
If you would like to draw off a coffee immediately after the
steam, proceed as described under point 10.1.
The maximum draw-off period is about 8 minutes.
Due to the system set-up, some water can come out and can
be let off before the actual drawing-off of steam. The good
result, e.g. in the frothing of milk, is not influenced in any
way.
12
is pressed by mistake, the choice
. The symbol flashes.
When steam is drawn off, there can be spattering at the
beginning. The pivoting nozzle for hot water/steam (18)
becomes hot. Avoid direct contact with the skin.

10.1 Return to readiness for coffee

Press the selector key . The control lamp goes off. Now, the
machine gets ready to produce coffee. This process is automatic
and only takes a matter of seconds.
Clean the pivoting nozzle for hot water/steam (18) with a
soft cloth after each drawing-off of steam.
In the automatic return to readiness to make coffee, some
water always drips into the drip tray (1). If a lot of steam is
drawn off, the drip tray (1) must be emptied more often.

11. Drawing off hot water

Place a cup under the pivoting nozzle for hot water/steam (18)
and turn the selector key for coffee or hot water/steam (17) to
the symbol . The machine now gives off hot water.
In order to end the procedure, turn the selector key for coffee or
hot water/steam (17) back to the symbol
When water is drawn off, there can be spattering at the
beginning. The pivoting nozzle for hot water/steam (18)
becomes hot. Avoid direct contact with the skin.

12. Switching off the machine

When the machine is switched off, the rinsing programme is auto-
matically run again. Therefore, place an empty vessel under the
height-adjustable coffee spout (14) and push the ON/OFF
switch.
After the rinsing water has run into the cup, the machine switches
off. Pour the rinsing water down the drain.
.