Table of Contents
Advertisement
D Terminating a call
After completing a call, push [#] to disconnect (hang up).
IMPORTANT: If one person in the conversation terminates a
call, all participants will be cut off.
D Last number redial
Push [M], [M] to automatically redial the last number called.
• A high-pitched beep indicates that the number is accepted.
D Memory speed-dialing
To automatically dial a commonly used number from memory:
Push [M] followed by the memory location (0–9).
D Turbo SpeeDial
To automatically dial a commonly used number with one
push:
Push one of the turbo SpeeDials ([A], [B], [C] or [D]).
OPTIONAL SmarTrunk II™ OPERATION
D Programming memory speed dial
➀
Push and hold [M] until you hear a high-pitched beep.
➁
Enter the memory location (0–9, A, B, C, D), the telephone
or subscriber number, then [1], [M] (or [3], [M] if for another
system subscriber).
• A high-pitched beep indicates successful programming.
• Memories [A]–[D] are used for Turbo SpeeDial.
D System busy indication
If all calls are busy, three low beeps sound after you initiate a
call. Try the call again later.
D PTT dispatch operation
➀
Push [PTT] once (without dialing) to initiate a dispatch call.
➁
Begin talking after you hear three beeps (one short, high-
pitched, two very short, low-pitched).
➂
Receiving a dispatch call is indicated by the same three
beep sequence.
• It is not necessary to push [M] to answer a dispatch call.
D Emergency call
Push [0], [M] to initiate an emergency call.
• Contact your dealer for details.
4
15
Advertisement
Table of Contents
