Lens Installation; Adjustable Feet; Installing Projector In Proper Position - Christie 103-008100-01 Quick Reference Manual

LENS INSTALLATION

Before setting up the projector, install a projection lens on
the projector.
1. Before installation, check the area where the projector is
used and prepare a suitable lens. For the specifications of
a projection lens, contact sales dealer where you
purchased the projector.
2. For installation, refer to the installation manual of the
optional lens.
✔
Note:
•When installing the lens, remove the cover cap of the projector.
COVER CAP
English

ADJUSTABLE FEET

Projection angle can be adjusted up to 10.5 degrees with the
ADJUSTABLE FEET.
1 Lift the front of the projector and pull the FEET LOCK
LATCHES in each side of the projector.
2 Release the FEET LOCK LATCHES to lock the
ADJUSTABLE FEET and rotate the ADJUSTABLE FEET
to a proper height, and tilt.
3 To retract the ADJUSTABLE FEET, lift the front of the
projector and pull and undo the FEET LOCK LATCHES.

INSTALLING PROJECTOR IN PROPER POSITION

Install the projector properly. Improper installation may reduce the lamp life and cause a fire hazard.
10˚
Do not tilt the projector more than 10 degrees from side to side.
10˚
Do not put the projector on either side to project an image.
NO SIDEWAYS
ADJUSTABLE FEET FEET LOCK
LATCHES