Specifications - Denon AVR-4308 Owner's Manual

GWireless LANH
Symptom Cause
Cannot connect • The settings of the
to network. and network key (WEP) are
incorrect.
• The reception is poor and the
signals cannot be received.
• There are multiple networks and
the usable channels overlap.
Played sound is • There are multiple networks and
interrupted or the usable channels overlap.
sound cannot be
played.
Noise in sound • The wireless LAN waves are
or picture when causing interference.
viewing TV or
listening to radio.
Countermeasure
SSID • Match the network settings with
the AVR-4308's settings.
• Shorten the distance from the
wireless LAN's access point,
remove any obstacles and
otherwise improve visibility, then
try reconnecting. Also install
away from microwave ovens
and the access points of other
networks.
• Set the access point's channel
settings away from the channels
used for other networks.
Alternatively, connect using a
network cable.
• Set the access point's channel
settings away from the channels
used for other networks.
Alternatively, connect using a
network cable.
Try one of the following methods:
• Try changing the product's place
of installation and the direction of
the antenna.
• Increase the separation between
the equipment and AVR-4308.
• Connect the product into an
outlet on a circuit different from
that to which the AVR-4308 is
connected.
Page
34

Specifications

–
n
Audio section
• Power amplifier
Rated output:
–
–
Dynamic power:
Output connectors:
• Analog
Input sensitivity / Input impedance:
–
Frequency response:
S/N:
Distortion:
–
Rated output:
• Digital
D/A output:
–
Digital input:
• Phono equalizer (PHONO input — REC OUT)
Input sensitivity:
RIAA deviation:
S/N:
Rated output:
Distortion factor:
Front:
140 W + 140 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Center:
140 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround (A + B):
140 W + 140 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Surround back:
140 W + 140 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
170 W + 170 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
150 W x 2ch (8 Ω/ohms)
220 W x 2ch (4 Ω/ohms)
Front, Center, Surround back 6 ~ 16 Ω/ohms
Surround: A or B 6 ~ 16 Ω/ohms
A + B 8 ~ 16 Ω/ohms
200 mV / 47 kΩ/kohms
10 Hz ~ 100 kHz — +1, –3 dB (DIRECT mode)
102 dB (DIRECT mode)
0.005 % (20 Hz ~ 20 kHz) (DIRECT mode)
1.2 V
Rated output — 2 V (at 0 dB playback)
Total harmonic distortion — 0.008 % (1 kHz, at 0 dB)
S/N ratio — 102 dB
Dynamic range — 100 dB
Format — Digital audio interface
2.5 mV
±1 dB (20 Hz to 20 kHz)
74 dB (A weighting, with 5 mV input)
150 mV
0.03 % (1 kHz, 3 V)
ENGLISH