About The Remote Control Unit; Inserting The Batteries; Operating Range Of The Remote Control Unit - Denon AVR-4308 Owner's Manual

ENGLISH
About the Remote Control Unit
In addition to the AVR-4308, the included main remote control unit
(RC-1068) can also be used to operate the equipment listed below.
q DENON system components
w Non-DENON system components
• By setting the preset memory (vpage 64 ~ 66)
• By using the learn function (vpage 67)
Inserting the Batteries
q Lift the clasp and remove the rear lid.
(RC-1068)
w Load the two batteries properly as indicated by the marks in the
battery compartment.
(RC-1068)
LR6/AA
e Put the rear cover back on.

NOTE
• Replace the batteries with new ones if the set does not operate even
when the remote control unit is operated close to the unit.
• The supplied batteries are only for verifying operation.
• When inserting the batteries, be sure to do so in the proper direction,
following the "q" and "w" marks in the battery compartment.
• To prevent damage or leakage of battery fluid:
• Do not use a new battery together with an old one.
• Do not use two different types of batteries.
• Do not attempt to charge dry batteries.
• Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
• If the battery fluid should leak, carefully wipe the fluid off the inside
(RC-1070)
of the battery compartment and insert new batteries.
• Remove the batteries from the remote control unit if it will not be in
use for long periods.
• When replacing the batteries, have the new batteries ready and
insert them as quickly as possible.
(RC-1070)
R03/AAA
Operating Range of the Remote Control
Unit
Point the remote control unit at the remote sensor when operating it.
30°
30°
Approx. 7 m
NOTE
The set may function improperly or the remote control unit may not
operate if the remote control sensor is exposed to direct sunlight,
strong artificial light from an inverter type fluorescent lamp or infrared
light.
(RC-1070)
or
(RC-1068)