What To Do If - AEG EE2000001 User Manual

Removing and cleaning the door glass panels
1. Remove the door.
2. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
3. Pull the door trim to the front to re-
move it.
4. Hold the door glass panels on their top
edge one by one and pull them up out
of the guide
5. Clean the door glass panels.
To install panels follow the procedure in re-
verse. Install the smaller panel first, then the
larger.

WHAT TO DO IF...

WARNING!
Refer to "Safety information" chapter.
Problem
The cooking zones do not oper-
ate.
The oven does not heat up.
The oven does not heat up.
The oven lamp does not oper-
ate.
Steam and condensation settle
on the food and in the oven
cavity.
If you cannot find a solution to the problem yourself, contact your dealer or the service
centre.
The necessary data for the service centre is on the rating plate. The rating plate is on the
front frame of the appliance cavity.
Possible cause
Consult the operating instructions for the built-in cooking sur-
face.
The oven is not switched on.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
You left the dish in the oven
for too long.
What to do if...
B
Remedy
Switch on the oven (refer to
chapter "Daily use").
Control the fuse. If the fuse is
released more than one time,
refer to a qualified electrician.
Replace the oven lamp.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
25