About Control Out Connections; Connecting Using Hdmi - Pioneer LX03 Operating Instructions Manual

12 Other connections

About control out connections

Many Pioneer components support CONTROL
connections, by which you can use the remote
controls of any connected components by
aiming them at the sensor of just one
component.
When you use a remote control, the control
signal is passed along the chain to the
appropriate component.
If you choose to use this feature, you must
make sure that you also have at least one set of
HDMI or analog audio jacks connected to
another component for grounding purposes.
• Using a cable with a mono mini-plug on
either end, connect the CONTROL IN jack on
another Pioneer component to the CONTROL
OUT jack on the rear panel.
This will allow you to control the other
component by pointing its remote at the front
panel.
Note
1 • An HDMI connection can only be made with DVI-equipped components compatible with both DVI and High Bandwidth
Digital Content Protection (HDCP). If you choose to connect to a DVI connector, you will need a separate adaptor (DVIHDMI)
to do so. A DVI connection, however, does not support audio signals. Consult your local audio dealer for more information.
• This system has been designed to be compliant with HDMI (High-Definition Multimedia Interface).
• When HDMI Audio is set to TV, sound is output from this unit to the TV connected to the HDMI connectors in for audio format
supported by that TV.
• Depending on the component you have connected, using a DVI connection may result in unreliable signal transfers.
62
En

Connecting using HDMI

If you have a HDMI or DVI (with HDCP)
equipped monitor or display, you can connect
it to this system using a commercially available
HDMI cable for high quality digital video.
See About HDMI on page 64 for more about the
HDMI connection.
To HDMI input
AV CONNECTOR
EO OUT
OUT IN 2 IN 1
HDMI
HDMI/DVI-equipped component
1
TV
OPTICAL
1
ANALOG 2 AM
LOOP
FM
2
UNBAL
75
ANTENNA
DIGITAL IN
From HDMI output