Using The On-Screen Displays - Pioneer LX03 Operating Instructions Manual

Getting started
• If the ambient noise level is too high,
Noisy! blinks in the display for five
seconds. To exit and check the noise
1
levels , press MCACC, or to try again, press
ENTER when Retry shows in the display.
• If you see an Error MIC! or Error Speaker!
message in the display, there may be a
problem with the microphone or the
speaker connections. To try again, press
2
.
ENTER
When the MCACC setup is complete, the
volume level returns to normal, Complete
shows in the display, and Acoustic Calibration
4
EQ is activated.
• Be sure to disconnect the microphone
from this unit upon completion of the Auto
MCACC setup.
Note
1 • If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles
blocking the speakers from the microphone) the final settings may be incorrect. Check for household appliances (air
conditioner, fridge, fan, etc.), that may be affecting the environment and switch them off if necessary.
• Some older TVs may interfere with the operation of the microphone. If this seems to be happening, switch off the TV during
Auto MCACC setup.
2 If this doesn't work, press MCACC, turn off the power, and check the problem indicated by the Error message, then try the
Auto MCACC setup again.
3 If Complete doesn't appear, it is likely an error occurred during the setup. Please check all connections and try again.
4 See Listening with Acoustic Calibration EQ on page 29 to switch on/off Acoustic Calibration EQ.
5 The screen saver will appear after five minutes of inactivity.

Using the on-screen displays

Simple and convenient graphic on-screen
displays (OSDs) are used when this system is
connected to a television.
All the screens are navigated in basically the
same way, using /// to change the
highlighted item and pressing ENTER to select
5
it.
3
Important
• Throughout this manual, 'Select' means
use the cursor buttons to highlight an item
on-screen, then press ENTER.
Button What it does
Displays/exits the on-screen display.
HOME MENU
Changes the highlighted menu item.
Selects the highlighted menu item.
ENTER
Returns to the main menu without
RETURN
saving changes.
Tip
• The button guide at the bottom of every
OSD screen shows you which buttons
you'll need to use for that screen.
04
23
En