Pioneer LX03 Operating Instructions Manual page 13

Connecting up
1 Assemble the AM loop antenna.
fig. a fig. b
a. Bend the stand in the direction indicated by
the arrow.
b. Clip the loop onto the stand.
c. If you want to fix to a wall or other surface,
perform step b after first securing the
stand with screws.
It is recommended that you determine the
reception strength before securing the
stand with the screws.
2 Connect the AM and FM antennas
a. Connect one wire of the AM loop antenna
to each AM antenna terminal
For each terminal, press down on the tab to
open; insert the wire, then release to
secure.
2
b. Push the FM antenna
pin of the FM antenna socket.
Note
1 • Keep antenna cables away from the receiver and other cables.
• If reception with the supplied antenna is poor, see Improving poor FM reception and Improving poor AM sound on
page 45 or Connecting external antennas on page 61.
• Do not attach any antenna other than the provided loop antenna, or an external antenna as described on page 61.
2 • Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical
appliances.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3 To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of
the unit.
fig. c
1
.
2
.
3
1
3
plug onto the center
3 Connect each speaker.
• You may purchase and use your own
speaker cables if desired. For details, see
Using your own speaker cables on page 78.
• The front and surround speaker cables
have a color-coded connector at one end
and two bare wires at the other end.
• Two purple cables are provided for the
subwoofer, one 4 meters and the other 10
meters in length. Use the appropriate cord
depending on the length needed for the
installation location.
• Since there is only one terminal to connect
the two center speakers, you will need to
use the supplied Y-cable for the connection.
• Twist and pull off the protective shields on
each wire.
• Connect the wires to the speaker. Each
speaker in the illustration can be identified
by means of the color-coded indicator
provided on the rear-surface label.
Color-coded wire
(Connect to speaker)
Color-coded connector
(Connect to rear panel)
02
13
En