Connecting An Ipod; Listening To An External Audio Source; Connecting External Antennas; About Control Out Connections - Pioneer LX01BD Operating Instructions Manual

Connecting an iPod

08
You can use the iPod jack on the display unit to playback music from
an iPod. All operations can be carried out via the iPod. Use the
supplied iPod cable to connect an iPod to this unit.
• When you connect an iPod, this unit's input automatically
switches to iPod.
• Certain iPod models have connectors that are not compatible
with this unit.
SYSTEM
iPod
MENU
iPod is a trademark of Apple Inc., registered in the U.S. and other
countries.

Listening to an external audio source

To listen to audio from a connected external component on this unit,
choose its input function on the remote control. Some Pioneer
products can be controlled via this remote.
1 If the system isn't already on, press SYSTEM ON to switch on.
Also make sure that the external source (TV, satellite receiver, etc.)
is switched on.
2 Press LINE to select an audio input source.
Input sources are cycled through as shown below:
Digital 1
Front Audio In
The display changes to that of the selected input source.
42
3 If necessary, start playback of the external source.
En
DISPLAY UNIT
iPod
MCACC
F.AUDIO SETUP MIC
Display unit
iPod
ON ON SYSTEM SYSTEM OFF
TV

INPUT
HDMI 1 HDMI 2 HDMI 3
BD DVR DVD TV
SOUND
DIRECT
RTRV
LINE LINE
TEST
MCACC SOUND
TONE
Digital 2 Analog
iPod

Connecting external antennas

For an external AM antenna, use 5 to 6 meters of vinyl-insulated wire
and set up either indoors or outdoors. Leave the loop antenna
connected.
For an external FM antenna, use a PAL connector to hook up an
external FM antenna.
Receiver subwoofer
Side panel
AM loop antenna
External AM antenna
Indoor antenna
(vinyl-coated wire)
5 m to 6 m

About control out connections

Many Pioneer components support CONTROL connections, by
which you can use the remote controls of any connected
components by aiming them at the sensor of just one component.
When you use a remote control, the control signal is passed along
the chain to the appropriate component.
If you choose to use this feature, you must make sure that you also
have at least one set of HDMI or analog audio jacks connected to
another component for grounding purposes.
 Using a cable with mono mini-plugs on either side (sold
separately), connect the CONTROL IN jack on another Pioneer
component to the CONTROL OUT jack on the receiver
subwoofer.
This will allow you to control the other component by pointing its
remote at the display unit supplied with this receiver subwoofer.
External FM antenna
ANTENNA
AM LOOP
FM
UNBAL 75 Ω
PAL connector
Outdoor antenna