Changing The Display Mode; Key Lock Setting; Tv System Setting - Pioneer LX03 Operating Instructions Manual

14 Additional information

Changing the display mode

If no operation is performed for one minute, the
front panel display and button illumination
automatically turns off. The display will turn on
again automatically if a command is input or
movement is detected by the motion sensor.
To make the display remain on constantly, set
the display mode to Display On.
ENTER
1 Select 'Display Mode' from the
System Setup menu, then press ENTER.
ENTER
2 Adjust the setting, then press
ENTER to confirm the settings and exit.
• Auto Display – Turns off automatically if
no operation is performed for one minute.
• Display On – Displays constantly.
Even when set to not display, the display is
temporarily shown when you carry out a
control function.
• The motion sensor detects movement in
the left/right and up/down directions
within a distance of 2.5 m and an angle of
40º (20º only in the upper direction).
Walking towards the unit will reduce the
sensing range to 0.7 m.

Key lock setting

ENTER
1 Select 'Key Lock' from the System
Setup menu, then press ENTER.
ENTER
2 Adjust the setting, then press
ENTER to confirm the settings and exit.
• Lock On – Makes the front panel buttons
and controls inoperative.
Note
1 Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch
vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without
color. If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV
has a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands
at the top and bottom of the screen.
70
En
• Lock Off – Restores regular use of the front
panel buttons and controls.

TV system setting

The default setting of this system is Auto, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to Auto. If you find picture distortion with
some discs, set the TV system to match your
country or region's system. However, this may
restrict the kinds of disc you can watch. See
the table for the kinds of discs compatible with
each setting (Auto, PAL and NTSC).
ENTER
1 Select 'TV System' from the
System Setup menu, then press ENTER.
• Change TV SYS? is displayed.
ENTER
2 Press ENTER to confirm.
Change the TV system as follows:
• Auto  NTSC
• NTSC  PAL
• PAL  Auto
The system will automatically enter standby
mode, then turn ON once again. You will see
the new TV system setting in the display after
seeing Power On.
Media Type Format NTSC
DVD/Super VCD/ NTSC
Video CD/DivX
PAL
Video/WMV
—
CD/MP3/WMA/
MPEG-4 AAC/
JPEG/no disc
1
Player setting
PAL Auto
NTSC PAL NTSC
NTSC PAL PAL
NTSC PAL NTSC or
PAL