Connecting External Antennas; About Control Out Connections - Pioneer LX03BD Operating Instructions Manual

Other connections

Connecting external antennas

For an external AM antenna, use 5 to 6 meters
of vinyl-insulated wire and set up either indoors
or outdoors. Leave the loop antenna
connected.
For an external FM antenna, use a PAL
connector to hook up an external FM antenna.
External AM antenna
Indoor antenna
(vinyl-coated Wire)
(5 m to 6 m)
Outdoor antenna
External
FM antenna
OPTICAL
1
AM
LOOP
FM
2
UNBAL
75
ANTENNA
DIGITAL IN
PAL connector

About control out connections

Many Pioneer components support CONTROL
connections, by which you can use the remote
controls of any connected components by
aiming them at the sensor of just one
component.
When you use a remote control, the control
signal is passed along the chain to the
appropriate component.
If you choose to use this feature, you must
make sure that you also have at least one set of
HDMI or analog audio jacks connected to
another component for grounding purposes.
• Using a cable with a mono mini-plug on
either end, connect the CONTROL IN jack on
another Pioneer component to the CONTROL
OUT jack on the rear panel.
This will allow you to control the other
component by pointing its remote at the front
panel.
09
49
En