Yamaha TMAX XP500 Owner's Manual page 23

fuel meter indicates the amount of fuel
in the fuel tank. The display segments
of the fuel meter disappear towards "E"
(Empty) as the fuel level decreases.
When the fuel level reaches the bottom
segment near "E", the fuel level warn-
ing indicator, "F", "E", and the bottom
segment will flash. Refuel as soon as
possible.
Coolant temperature meter
With the key in the "ON" position, the
coolant temperature meter indicates
the temperature of the coolant. The
coolant temperature varies with chang-
es in the weather and engine load. If
the top segment, "H", "C", and coolant
temperature warning indicator flash,
stop the vehicle and let the engine cool.
INSTRUMENT AND CONTROL FUNCTIONS
(See page 6-38.)
NOTICE
Do not continue to operate the en-
gine if it is overheating.
Oil change indicator "Oil"
1
1. Oil change indicator "Oil"
3-8
This indicator flashes at the initial 1000
km (600 mi), then at 5000 km (3000 mi)
and every 5000 km (3000 mi) thereafter
to indicate that the engine oil should be
changed.
After changing the engine oil, reset the
oil change indicator. To reset the oil
change indicator, select it by pushing
the left set button until "Oil Trip" is dis-
played, and then push the left set but-
ton at least one second. When pushing
ECA10021
the left set button, "Oil Trip" starts flash-
ing. While "Oil Trip" is flashing, push the
left set button for at least three sec-
onds.
If the engine oil is changed before the
oil change indicator "Oil" flashes (i.e.
before the periodic oil change interval
has been reached), the indicator "Oil"
must be reset after the oil change for
the next periodic oil change to be indi-
cated at the correct time.
The electrical circuit of the indicator can
be checked according to the following
procedure.
1. Set the engine stop switch to "
and turn the key to "ON".
2. Check that the oil change indicator
comes on for a few seconds and
2
3
4
5
6
7
8
9
"