Introduction; Manual Organization; Symbol Used In This Manual; General Safety Information - DCA Intertel s’print BT User Manual

INTRODUCTION

MANUAL ORGANIZATION

In addition to the Introduction which includes a description of the explanatory notes
used in the manual, general safety information, how to unpack the printer and a brief
description of the printer including its basic features, this manual is organized as fol-
lows:
Chapter 1: Contains the information required for correct printer installation and its
proper use, as well as interface specifications
Chapter 2: Contains information on interface specifications
Chapter 3: Contains a description of the printer command set
Chapter 4: Contains Technical Specifications of the printer
Chapter 5: Contains the character sets (fonts) used by the printer

SYMBOL USED IN THIS MANUAL

NOTE
Gives important information or suggestions relative to the use of the
printer.
WARNING
Information marked with this symbol must be carefully followed to
guard against damaging the printer.
DANGER
Information marked with this symbol must be carefully followed to
guard against operator injury or damage.

GENERAL SAFETY INFORMATION

-Read and keep the instructions which follow.
-Before cleaning the printer, disconnect the power supply and make sure that the prin-
ter is off.
-Clean the printer with a damp cloth. Do not use liquid or spray products.
-Do not operate the printer near water.
-Only use approved accessories and batteries. Do not connect to
products that are not compatible.
-Use the type of electrical power supply indicated on the printer label. If in doubt, con-
tact your retailer.
-When deciding where to place the printer, make sure it is positioned
where its cables will not be damaged.
-Do not introduce foreign objects of any kind into the printer as they could cause a
short circuit and could jeopardize printer functioning.
-Do not spill liquids onto the printer.
-Do not carry out technical operations on the printer, with the exception of the sche-
duled maintenance procedures specifically indicated in the user manual.
-Disconnect the printer from the electricity supply and have it repaired by a speciali-
zed technician when:
A. The feed connector has been damaged.
B. Liquid has seeped inside of the printer.
C. The printer has been exposed to rain or water.
DCA Intertel 6 DCA Intertel