[Notes]
• If the bit image data input exceeds the number of dots to be
printed on a line, the excess data are processed as printable
characters.
• d indicates the bit image data. Set a corresponding bit to 1 to print
a dot, or to 0 to not print the dot.
• This command is not affected by the emphasized, doublestrike,
underline (etc.) print modes, except for the upsidedown mode.
[Default]
[Reference]
[Example]
For printing 12 bytes the command sequence is :
1D 57 0C FF 00 FF 00 FF 00 FF 00 FF 00 FF 00
GS + (nH) (nL)
[Name]
Aligns the ticket at the first printed line
[Format]
ASCII
Hex
Decimal
[Description]
This command searches for the reference notch on the paper and
aligns the ticket at the first line to be printed.
[Note]
nH and nL are the values of the shift to be made once the notch has
been found
The command is only performed if alignment is enabled under
setup (see parameter)
[Reference]
[Example]
To print a logo on a ticket that is 25 mm long with the hole (or
notch) at the end of the ticket, the following command must
be sent:
0x1D, 0xF6, 0xFF, 0x7B (perform alignment)
0x1B, 0xFA, 0x00, 0x55 (print logo)
In this example, nH and nL are expressed in module 2 so that the
motor will recede.
DCA
Intertel
GS
??
(nH) (nL)
1D
F6
(nH) (nL)
29
246
(nH) (nL)
53
DCA
Intertel