Related Manuals for DCA Intertel MP2005
Summary of Contents for DCA Intertel MP2005
-
Page 1: User Manual
User Manual MP2005 Mobile Impact Printer 80 Column Dot Matrix www.dca-group.com Intertel Intertel V1.1... -
Page 2: Table Of Contents
Table of Contans 5. Printer Operation 5.1 Control Keys 1.Customer Care And Service 5.2 Power Source 1.1 Warranty And Repair Service 5.3 Paper Loading 1.2 Application Support 5.4 Sensors 1.3 Notice 5.5 Maintenance 1.4 Warning 5.6 Inked Ribbon Cartridge Installation and 1.5 Limited Warranty Replacement 2. -
Page 3: Customer Care And Service
1.3 Notice purchaser. Within this period DCA Intertel will repair or replace the product without charge for material or la- The information contained in this document is subject to bor. -
Page 4: Description
2. Description 2.2 Printer Layout 2.1 Printer Overview The MP- 2005 Mobile Printer is a ruggedized dot matrix printer designed specifically for mobile and portable ap- plications. It can print in graphics mode along with diffe- rent character fonts, both in draft ( 150 cps ) and NLQ ( 25 cps ) mode. -
Page 5: Technical Specifications
3. Technical Specifications 4. Installation 4.1 Unpacking Weight: 7 kg. Take the printer out of its shipping box and remove any Power: 11-14,0 Volts DC packing material. It is advisable to keep the shipping box 85 mA Standby in case the printer needs to be reshipped or stored 2.5 A at medium print density elsewhere. -
Page 6: Printer Setup
4.3 Printer Setup TABLE 2 - BAUD RATE SELECTION The MP-2005 can be configured by using the DIP-swit- Baud Rate SW 1-1 SW 1-2 ches as shown in Fig. 1. The function of the DIP-switches is depicted in Table 1. 1200 2400 TABLE 1 - DIP SWITCHES... -
Page 7: Caution
4.4 Caution! NOTE: The small size of the printhead did not allow for a * Do Not print without inked ribbon or paper, since this headpaper spacing adjustment device to be used in leads to rapid printhead needle wear- out. single-copy or multi copy printing. -
Page 8: Indicators
5. Printer Operation 4.6 Indicators POWER ON The MP-2005 control panel is fitted with four control This indicator lights when the printer is correctly powe- keys, three indicators of which one is an alarm indicator. red. 5.1 Control Keys ON LINE Turns on when the printer is ready to accept data. -
Page 9: Power Source
● Open the printer by lifting lever A (Fig. 2.) ● Insert single-sheet module by placing it over the DCA Intertel printing plate, while checking if it is equally spaced ONLINE with respect to the printing area; in case of... -
Page 10: Sensors
CAUTION The PAPER END sensor is also used to detect an “open If the printer has been printing for some time it is ad- mechanism” condition. When the mechanism is open, the visable not to touch the printhead during paper loading or sensor no longer sees the sheet and actions described inkribbon cartridge replacement, as it could be very hot. -
Page 11: Inked Ribbon Cartridge Installation And Replacement
5.6 Inked Ribbon Cartridge Installation and Replacement Cartridge installation/replacement procedure: ● Turn the printer off. ● Remove used cartridge by unlocking bottom latch and then rotating cartridge body upwards as shown by arrow D. ● Place ribbon extender on both studs B until it locks down, paying attention to the ribbon not disengaging from the extender itself. -
Page 12: Interfaces
6. Interfaces 6.2 Appendix B: 6.1 Appendix A: CHARACTER SET ASCII 256 IBM The printer comes with standard RS 232 Serial Interface DEC. HEX. Characters control key ASCII name Ctrl @ null SIGNAL SIGNAL Ctrl A start of heading Ctrl B start of text Carrier Detect Frame Ground...