Batteries; Recharging Batteries - DCA Intertel s’print BT User Manual

1.2 BATTERIES

1.2.1 Recharging batteries

Appearing in the printer set up print out (see sec. 1.3) is the parameter
HEAD VOLT that gives the battery charge level. To recharge the batteries(4), use the
cable packed with the printer and proceed as follows:
- Connect the battery recharger jack to the cable jack (vedi fig. 1.4) and plug the bat-
tery recharger into the electrical mains;
- Connect the cable RJ11 connector to the RJ11 connector located under the printer
(see fig. 1.4). For a complete recharge, we recommend that the batteries be left to
charge for two hours;
(4) NOTE
During the recharge operation it's not possible turning the printer off.
WARNING
Incorrect battery recharge voltage (different from that given in tab.
1.2) could seriously damage the printer.
Tables 1.1 and 1.2 provide specifications for the battery recharger
Pin
1
2
DCA Intertel
Signal
+VRIC
GND
MAX recharge current
MAX recharge voltage
IN/OUT Description
Power Battery recharge
Power Ground signal
0.6 A
12V - 36V
13 DCA Intertel