Revolabs Solo™ Wireless Microphone; Wearable Microphone; Tabletop Microphone; Charging The Batteries - Revolabs SOLO 02-DSKSYS Installation And Operation Manual

Revolabs Solo™ Wireless Microphone

Wearable Microphone

The wireless personal microphone can be worn on the user's shirt
pocket, lapel or on a lanyard. It provides high quality full duplex
audio between the user and the computer and/or phone system.
The system allows the wearer to step out of the office or
conference room and still participate in the call.
1 2
1. Pocket Clip — attaches microphone to the user
2. LED Indicator — visual status for mute, un-mute, and pairing
Mute
3. Button — press to mute, un-mute and pair microphone
4. Earpiece Jack — accepts the 2.5mm plug for the earpiece
5. Charging Port — docks to all Revolabs Solo™ battery chargers

TableTop Microphone

The Revolabs Solo™ TableTop Wireless
Boundary Microphones enable multiple
phone conference participants to use a
single microphone. Units are placed
strategically on the conference table to
ensure that all participants can be heard
clearly - without wires getting in the way or
limiting the distance to the speaker unit.
Mute
1. Button — press to mute, un-mute and pair microphone
2. LED display — visual status for mute, un-mute, and pairing
3. Integral grille — protects internal parts (non-removable)
4. Audio jack — accepts a 2.5mm plug for a powered speaker
5. Charging port — docks to all Revolabs Solo™ battery chargers
6. Rubber feet — non-slip, vibration absorbing pads
8
4 5
3
4
1
2
6
3

Charging the Batteries

How to Charge
1. Place the Microphone into the Desktop Charger Base.
2. During charging, the Microphone status LED
indicator is solid RED and remains on until
charging completes and then turns off. The
Charger Base status indicator remains off
during charging. The Microphone is always
muted while in the Charger Base. The battery
charges from fully depleted to fully charged in
about two hours. It can be "quick-charged" to
approximately 80% capacity in 45 minutes.
3. When charging completes, the Microphone RED LED turns off
and Microphone is ready for use.
battery provides approximately 8 hours of talk time.
4. If the Microphone is left in the Charger Base for an extended
period, the LED will turn on again indicating a top-up charge.
When to Charge
First-time use — before use the Microphone, charge it for 8 hours
or overnight in the Charger Base (until microphone LED turns off).
Recharging — when the Microphone LED begins flashing
alternating YELLOW and RED or YELLOW and GREEN, the
5
battery needs recharging. Over time (years), batteries gradually
wear down and require charging after a shorter period of use. This
is normal.
The Lithium Polymer rechargeable battery that powers the
Microphone is not user serviceable. Please see the Revolabs
Knowledge Base website area (www.revolabs.com) for
replacement instructions and to assure that the proper disposal
method is used. Warning: Never dispose of batteries in a fire
because they may explode.
Note: A fully charged
9