The Wlan Button - ZyXEL Communications P-2812HNU-51c User Manual

You can set up a wireless network with WPS (WiFi Protected Setup) or manually add a client to your
wireless network.
Figure 3 Wireless Connection Application
WLAN
LAN

1.3 The WLAN Button

You can use the WLAN ON/OFF button on top of the device to turn the wireless LAN on or off. You
can also use it to activate WPS in order to quickly set up a wireless network with strong security.
Turn the Wireless LAN On or Off
Make sure the POWER LED is on (not blinking).
1
Press the WLAN ON/OFF button for one second and release it. The WLAN/WPS LED should change
2
from on to off or vice versa.
Activate WPS
Make sure the POWER LED is on (not blinking).
1
Press the WLAN ON/OFF button for more than five seconds and release it. Press the WPS button on
2
another WPS -enabled device within range of the Device. The WLAN/WPS LED should flash while
the Device sets up a WPS connection with the wireless device.
Note: You must activate WPS in the Device and in another wireless device within two
minutes of each other. See
P-2812HNU(L)-Fx Series User's Guide
Chapter 6 on page 142
Chapter 1 Introduction
WAN
for more information.
23