ZyXEL Communications P-2812HNU-51c User Manual page 102

Chapter 5 Broadband
Table 9 Broadband Add/Edit: Routing- PPPoE (ADSL) (continued)
LABEL
Maximum Burst
Size
PPP Information
PPP User Name
PPP Password
PPPoE Service
Name
Authentication
Mode
Use Static IP
Address
IP Address
Routing Feature
NAT Enable
IGMP Proxy Enable
Apply as Default
Gateway
DNS Server
Obtain DNS info
Automatically
Use the following
Static DNS IP
Address
Primary DNS
Server
Secondary DNS
Server
IPv6 Address
102
DESCRIPTION
Maximum Burst Size (MBS) refers to the maximum number of cells that can be
sent at the peak rate. Type the MBS, which is less than 65535.
This field is available only when you select Non Realtime VBR or Realtime
VBR.
This section is available only when you select Routing in the Mode field and
PPPoE or PPPoA in the WAN Service Type field.
Enter the user name exactly as your ISP assigned. If assigned a name in the
form user@domain where domain identifies a service name, then enter both
components exactly as given.
Enter the password associated with the user name above.
Type the name of your PPPoE service here.
The Device supports PAP (Password Authentication Protocol) and CHAP
(Challenge Handshake Authentication Protocol). CHAP is more secure than PAP;
however, PAP is readily available on more platforms.
Use the drop-down list box to select an authentication protocol for outgoing
calls. Options are:
• AUTO: Your Device accepts either CHAP or PAP when requested by this
remote node.
• CHAP: Your Device accepts CHAP only.
• PAP: Your Device accepts PAP only.
• MS-CHAP: Your Device accepts MSCHAP only. MS-CHAP is the Microsoft
version of the CHAP.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address
is not fixed; the ISP assigns you a different one each time you connect to the
Internet. Select this if you want to get a dynamic IP address from the ISP.
Enter the static IP address provided by your ISP.
Select this option to activate NAT on this connection.
Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to
establish membership in a Multicast group - it is not used to carry user data.
Select this option to have the Device act as an IGMP proxy on this connection.
This allows the Device to get subscribing information and maintain a joined
member list for each multicast group. It can reduce multicast traffic
significantly.
Select this option to have the Device use the WAN interface of this connection
as the system default gateway.
The section is not available when you select Bridge in the WAN Service Type
field.
Select this to have the Device get the DNS server addresses from the ISP
automatically.
Select this to have the Device use the DNS server addresses you configure
manually.
Enter the first DNS server address assigned by the ISP.
Enter the second DNS server address assigned by the ISP.
This section is not available when you select Disable in the IPv6/IPv4
DualStack field.
P-2812HNU(L)-Fx Series User's Guide