Configuring The Managed Access Points List - ZyXEL Communications NWA-3500 User Manual

Chapter 3 Tutorial
To set your NWA in managed AP mode, open the MGNT screen in the Web
1
Configurator of the NWA that you want to serve as a managed AP.
Figure 48 Tutorial: Managed AP
Select Managed AP and enter the IP addresses of the NWA primary and
2
secondary controller AP (recommended). Click Apply.
Note: DCHP Server Option 43 enables your managed AP to send a request to be
managed to controller APs that are within range, even if the controller AP
belongs to another network.
You are logged out of the Web Configurator and the screen shows a message that
3
the device is rebooting. You lose access to the Web Configurator.
You must now add the NWA managed APs to the controller's managed AP list.

3.6.6 Configuring the Managed Access Points List

At this point, you have 3 NWA managed APs (B, C and D) that can now be
managed by the primary controller AP.
First in the Web Configurator of your primary controller AP (A), go to Controller
> Configuration.
Figure 49 Tutorial: Registration Type
76
NWA-3500/NWA-3550 User's Guide