Scenario; Configuring The Zyxel Device In Access Point Mode; Figure 14 Ftp Server Connected To A Wireless Client - ZyXEL Communications 802.11b/g Wireless Access Point NWA-1100 User Manual

4.2.1 Scenario

In the figure below, there are two ZyXEL Devices (A and B) in the network. A is in Access
Point (AP) mode while B is in Wireless Client mode. Station B is connected to a File Transfer
Protocol (FTP) server. You want only specified wireless clients to be able to access station B.
You also want to allow wireless traffic between B and wireless clients connected to A (W, Y
and Z). Other wireless devices (X) must not be able to connect to the FTP server.

Figure 14 FTP Server Connected to a Wireless Client

4.2.2 Configuring the ZyXEL Device in Access Point Mode

Before setting up the ZyXEL Device as a wireless client (B), you need to make sure there is an
access point to connect to. Use the Ethernet port on your ZyXEL Device to configure it via a
wired connection.
Open the Web Configurator and go to the Wireless > Wireless Settings screen.
ZyXEL NWA-1100 User's Guide
Chapter 4 Tutorial
Access
Denied
45