Powering The Polycom Hdx 4500 System On And Off; Power On Self Test (Post) - Polycom HDX 4000 User Manual

User's Guide for Polycom HDX Desktop Systems

Powering the Polycom HDX 4500 System On and Off

Power On Self Test (POST)

4
To power off the Polycom HDX 4000 system:
>> Press and hold the power button on the front of the system or press and
hold the power button on the side of the monitor.
The monitor and the system power off.
After turning the power off in this way, wait at least 15 seconds before you
disconnect the system from its power source.
To power off the Polycom HDX 4000 system monitor:
>> Press the power button on the side of the monitor.
The monitor enters standby mode. The system stays powered on.
To power on the Polycom HDX 4500 system:
>> Press the power button on the side of the system.
The Polycom splash screen is displayed within about 10 seconds.
To power off the Polycom HDX 4500 system:
>> Press and hold the power button on the side of the monitor.
The monitor and the system power off.
To power off the Polycom HDX 4500 system monitor:
>> Press the power button on the side of the monitor.
The monitor enters standby mode. The system stays powered on.
After the splash screen is displayed, the HDX system automatically performs
system health checks every time the system starts. As each check begins, a
message appears on Monitor 1.
If a test fails, press
the startup process. However, even if the system appears to start up, Polycom
recommends that you contact Technical Support before using your HDX
system if any of the system tests fail.
Hangup on the remote control or keypad to continue
Polycom, Inc.