Wall Control Installation - Casablanca Isotope Owner's Manual

Wall Control
WARNING! To avoid possible electrical shock,
make certain that electricity is turned off at the
circuit breaker or fuse box before attempting any
installation or repair procedure.
CAUTION! NOT turning the power OFF at the circuit breaker
or fuse box may cause damage to the electronics within the fan.
NOTE: Wall Control should only be installed on Casablanca 5xxxx Series Fans.
This controller is designed to signal the fan's
microcomputer as well as perform normal
switching operations. For this reason the following
precautions must be observed:
1.
Use only the Casablanca wall control.
2.
Do not use any additional control with your fan
(for example, dimmer, or fan speed control).
WARNING!
Ensure power is turned OFF at the
breaker or fuse panel before starting installation.
3.
After removing the switch plate cover, remove all
wiring from the switch. Figure 17.
4.
Using orange wire connectors, connect the
two black wires (ungrounded) from the outlet
box. Also connect the two green or bare wires
(grounding) from the outlet box with the
grounding wire from the wall control. Figure 18.
Switch
Mounting
Cover Plate Screws (2)

WALL CONTROL INSTALLATION

12
12
Cover Plate
Screws (2) (3) Wire Connector
Fuse Box
(Remove fuse for the
circuit you will be
working on)
Before After
Before After
Circuit Breaker
(Trip breaker for the
circuit you will be
working on)
Figure 17
Figure 18