Table of Contents
Advertisement
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you
wish to place your Casablanca fan, an approved ceiling
fixture outlet box must be installed and wired.
WARNING!
To reduce the risk of fire, electrical shock, or
personal injury, mount to outlet box marked
"Acceptable for Ceiling Fan Support" using the
mounting hardware provided with the outlet box.
CROSSBAR MOUNTING BRACKET INSTALLATION
CEILING HARDWARE (not to scale)
Crossbar Mounting Bracket
Note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2x4 stud must be installed.
Step 1a. Remove the knockout plug in the center of the
outlet box or drill a
1
/
-inch hole for the lag screw to pass
2
through. Then drill a
1
/
-inch guide hole into the joist or
4
beam to a depth of 3 inches.
Step 1b. Route the outlet box wires through the keyhole
slot of the crossbar mounting bracket as shown. Attach
the crossbar mounting bracket to outlet box with screws
provided, assuring that the outlet box wires are not pinched
by the washer.
CAUTION:
To reduce the risk of personal injury, use only
the mounting hardware provided with the
approved outlet box to install the crossbar
mounting bracket.
WARNING!
Support directly to building structure only.
4
FAN INSTALLATION
GETTING STARTED
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit
breaker or fuse box), lower the old fixture and disconnect
the wiring. Check the ceiling fixture outlet box to be sure
that it is marked "Approved for Ceiling Fan Mounting." If
it is not, a new box must be installed.
Note: The weight of this fan is 35 pounds.
Screw Pack A:
Lag Screw and Washer (1)
1" x 8-32 Roundhead Screw and Washer (2)
Ceiling-Fan-
Approved
Wiring Box
Crossbar Mounting
Bracket
Green Ground
Wire
1" x 8-32
Roundhead Screw
Joist
Wire Nut
(4)
Ceiling Wiring
Ridge side down
Washer
Advertisement
Table of Contents
