Chapter 7 Troubleshooting; Problems Starting The Zyxel Utility; Problem Connecting To An Access Point; Table 20 Troubleshooting Starting Zyxel Utility - ZyXEL Communications AG-225H User Manual

This chapter covers potential problems and the possible remedies. After each problem
description, some instructions are provided to help you to diagnose and to solve the problem.

7.1 Problems Starting the ZyXEL Utility

Table 20 Troubleshooting Starting ZyXEL Utility

PROBLEM
Cannot start the
ZyXEL Wireless
LAN utility
The ZyXEL utility
icon does not
display.

7.2 Problem Connecting to an Access Point

Table 21 Troubleshooting Access Point Connection Problem

PROBLEM
When using the
Windows XP
configuration tool,
the AG-225H v2
cannot scan for or
connect to any
access points.

Chapter 7 Troubleshooting

Troubleshooting
CORRECTIVE ACTION
Make sure the AG-225H v2 is properly inserted and the LED is on. Refer to the
Quick Start Guide for the LED descriptions.
Use the Device Manager to check for possible hardware conflicts. Click Start,
Settings, Control Panel, System, Hardware and Device Manager. Verify the
status of the AG-225H v2 under Network Adapter. (Steps may vary depending on
the version of Windows).
Install the AG-225H v2 in another computer.
If the error persists, you may have a hardware problem. In this case, you should
contact your local vendor.
If you have installed the Funk Odyssey Client software on the computer, uninstall
(remove) both the Funk Odyssey Client software and ZyXEL utility, and then install
the ZyXEL utility again after restarting the computer.
CORRECTIVE ACTION
The AG-225H v2 might still be operating in access point mode. This results when
you set the AG-225H v2 to operate in access point mode using the ZyXEL utility,
close the ZyXEL utility and then use the Windows XP configuration tool.
Before you use the Windows XP configuration tool, make sure you set the AG-
225H v2 to operate in station mode before you close and exit the ZyXEL utility.
ZyXEL AG-225H v2 User's Guide
C
H A P T E R
7
67