Security Settings; Wep Encryption; Figure 26 Station Mode: Security Setting: Wep; Table 6 Station Mode: Security Setting: Wep - ZyXEL Communications AG-225H User Manual

Table 5 Station Mode: Site Survey (continued)
LABEL
Encryption
MAC address
Surveyed at

4.3.1 Security Settings

When you configure the AG-225H v2 to connect to a network with wireless security activated
and the security settings are disabled on the AG-225H v2, the screen varies according to the
encryption method used by the selected network.

4.3.1.1 WEP Encryption

Figure 26 Station Mode: Security Setting: WEP

The following table describes the labels in this screen.

Table 6 Station Mode: Security Setting: WEP

LABEL
Security Settings
WEP
Authentication
Type
Pass Phrase
Transmit Key
Chapter 4 Wireless Station Mode Configuration
DESCRIPTION
This field shows whether data encryption is activated (WEP (WEP or 802.1x),
WPA, WPA-PSK, WPA2, WPA2-PSK) or inactive (DISABLE).
This field displays the MAC address of the wireless device.
This field displays the time when the wireless device was scanned.
DESCRIPTION
Select 64 Bits, 128 Bits or 256 Bits to activate WEP encryption and then fill in the
related fields.
Select an authentication method. Choices are Open or Shared. Refer to
3.2.3.1.2 on page 35 for more information.
Enter a passphrase of up to 63 case-sensitive printable characters. As you enter
the passphrase, the AG-225H v2 automatically generates four different WEP keys
and displays it in the key field below. Refer to
more information.
At the time of writing, you cannot use the passphrase function to generate 256-bit
WEP keys.
Select a default WEP key to use for data encryption. The key displays in the field
below.
ZyXEL AG-225H v2 User's Guide
Section 3.2.3.1.1 on page 35
Section
for
43