Figure 38 Station Mode: Adapter; Table 14 Station Mode: Adapter - ZyXEL Communications AG-225H User Manual

Figure 38 Station Mode: Adapter

The following table describes the labels in this screen.

Table 14 Station Mode: Adapter

LABEL
Adapter Setting
Transfer Rate
Preamble Type
Power Saving
Mode
Save
Chapter 4 Wireless Station Mode Configuration
DESCRIPTION
In most networking scenarios, the factory default Auto setting is the most efficient
and allows your AG-225H v2 to operate at the highest possible transmission (data)
rate.
If you want to select a specific transmission rate, select one that the AP or peer
wireless device supports.
Note: With USB1.0/1.1, the AG-225H v2 can only transmit at up to
11Mbps.
Preamble is used to signal that data is coming to the receiver. Select the preamble
type that the AP uses. Short and Long refer to the length of the synchronization
field in a packet.
Short preamble increases performance as less time sending preamble means
more time for sending data. All IEEE 802.11b/g compliant wireless adapters
support Long preamble, but not all support short preamble.
Select Auto to have the AG-225H v2 automatically use short preamble when all
access point or wireless stations support it; otherwise the AG-225H v2 uses long
preamble.
Note: The AG-225H v2 and the access point or wireless stations
MUST use the same preamble mode in order to
communicate.
Select Maximum Power Save or Fast Power Save to save power (especially for
notebook computers). This forces the AG-225H v2 to go to sleep mode when it is
not transmitting data.
When you select Continuous Access Mode, the AG-225H v2 will never go to
sleep mode.
Click Save to save the changes to the AG-225H v2.
ZyXEL AG-225H v2 User's Guide
55