Additional Setup Requirements; The Link Info Screen; Figure 40 Access Point Mode: Link Info; Table 16 Access Point Mode: Link Info - ZyXEL Communications AG-225H User Manual

ZyXEL AG-225H v2 User's Guide

5.1.2 Additional Setup Requirements

To bridge your wired and wireless network using the AG-225H v2, the following requirements
must be met:
1 The AG-225H v2 must be installed on a computer connected to the wired network.
2 Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen of the ZyXEL utility in Windows XP) or configure network
sharing (refer to
3 Set the wireless station's IP address to be dynamic if you want the wireless stations to
access the wired network or the Internet through the AG-225H v2. Refer to
on page 93

5.2 The Link Info Screen

Select the AP Mode check box and wait for about five seconds to display the screen as shown.

Figure 40 Access Point Mode: Link Info

The following table describes the labels in this screen.

Table 16 Access Point Mode: Link Info

LABEL
Status
SSID
Current Channel
Transmission Rate This field displays the current transmission rate of the AG-225H v2 in megabits per
58
Appendix B on page 71
for how to configure your computer's IP address.
DESCRIPTION
This field displays the name that identifies your AG-225H v2 in the wireless LAN
network.
This field displays the radio channel the AG-225H v2 is currently using.
second (Mbps).
for an example).
Chapter 5 Access Point Mode Configuration
Appendix E