Additional Setup Requirements; The Link Info Screen; Figure 48 Access Point Mode: Link Info; Table 16 Access Point Mode: Link Info - ZyXEL Communications G-202 User Manual

ZyXEL G-202 User's Guide

5.1.2 Additional Setup Requirements

To bridge your wired and wireless network using the G-202, the following requirements must
be met:
1 The G-202 must be installed on a computer connected to the wired network.
2 Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen of the ZyXEL utility in Windows XP) or configure network
sharing (refer to
3 Set the wireless station's IP address to be dynamic if you want the wireless stations to
access the wired network or the Internet through the G-202. Refer to
109 for how to configure your computer's IP address.

5.2 The Link Info Screen

Select the AP Mode check box and wait for about five seconds to display the screen as shown.

Figure 48 Access Point Mode: Link Info

The following table describes the labels in this screen.

Table 16 Access Point Mode: Link Info

LABEL
Status
SSID
74
Appendix B on page 87
DESCRIPTION
This field displays the name that identifies your G-202 in the wireless LAN network.
for an example).
Chapter 5 Access Point Mode Configuration
Appendix E on page