Access Point Mode Configuration; Access Point Mode Introduction; Additional Setup Requirements; The Link Info Screen - ZyXEL Communications ZyXEL ZyWALL 1 User Manual

This chapter shows you how to configure your ZyXEL G-220 v2 in access point mode.

4.1 Access Point Mode Introduction

To set your ZyXEL G-220 v2 as an Access Point (AP), refer to
In access point mode, your ZyXEL G-220 v2 functions as an access point. This allows you to
set up your wireless networks without using a dedicated AP device. Up to 16 wireless stations
can associate to the ZyXEL G-220 v2.

4.1.1 Additional Setup Requirements

To bridge your wired and wireless network using the ZyXEL G-220 v2, the following
requirements must be met:
1 The ZyXEL G-220 v2 must be installed on a computer connected to the wired network.
2 Either bridge the two interfaces (wireless and wired) on the computer (using the
Configuration screen of the ZyXEL utility in Windows XP) or configure network
sharing (refer to
3 Set the wireless station's IP address to be in the same subnet as the computer in which the
ZyXEL G-220 v2 is installed. Refer to

4.2 The Link Info Screen

Select the AP Mode radio button and wait for about five seconds to display the screen as
shown.
Chapter 4 Access Point Mode Configuration
Access Point Mode
Appendix B on page 67
Appendix F on page
ZyXEL G-220 v2 User's Guide
C
H A P T E R
Configuration
Section 1.7.1 on page
for an example).
95.
4
25.
53