GE D20MX User Manual page 78

Updating a D200 configuration to use the D20MX firmware
definition with ConfigPro
Prerequisites
Procedure
78
27. Review all warnings and make corrections as needed, reviewing the original copy to
retrieve values that may have been replaced with default values during the upgrade
28. Right-click on the device and click Generate.
Result: The device is displayed without a red dot.
29. Right-click on the device and click Archive > Save.
Result: The Save Device to ZIP File dialog appears.
30. In the "Save To" area, click the folder icon.
Result: A dialog appears with the title "Select a directory in which to save the project".
31. Navigate to a folder on your PC where you would like to save the device archive and
click Select and OK.
32. Close ConfigPro.
33. Migrate the D20 Device Archive into SGConfig
the Migration Wizard screencast).
Before you can update the firmware definition of a D200 device configuration, the
following components must be present
• ConfigPro 5.03 or higher installed on the configuration computer.
• The D20MX Documentation CD (part number 588-0075/00) installed in a CD/DVD drive
of the configuration computer.
Migrating a multi-processor D200 will only transfer the application configurations on the
first processor.
This is manually resolved by moving applications from other processors to the first
processor using the ConfigPro device editing functions BEFORE converting the device to a
D20 in the instructions below.

Single and multi-processor D200 devices must first be changed into D20 devices before
the D20MX firmware definition can be selected. To change a D200 device into a D20
device perform the following steps:
1. Start ConfigPro 5.03 or higher.
Result: The main window of ConfigPro appears with the tree view of the project
directory on the left.
2. Make a backup copy of the project you want to transfer to the D20MX.
2.1. Select from the menu, Project > Copy Project.
Result: The Copy Project dialog appears.
2.2. In the "From" area, navigate to the folder and select the project you want to
transfer to the D20MX.
2.3. In the "To" area, enter a new unique name for the project.
2.4. Click OK.
Result: The main window of ConfigPro appears with the tree view of the project
directory on the left.
3. On the tree view displayed to the left, navigate to the project and double-click on the
project name.
Result: The main window of the copied project appears
CHAPTER 5: CONFIGURING THE SOFTWARE
TM
using the Migration Wizard (Refer to
GENERAL D20MX HARDWARE USER'S MANUAL