GE D20MX User Manual page 71

CHAPTER 5: CONFIGURING THE SOFTWARE
D20MX HARDWARE USER'S MANUAL
11. Select a D20MX processor from the D20 Device Wizard:
11.1. Click the Project tab of the original D20 device configuration.
11.2. Click the D20 device.
11.3. Click the ribbon Configure group > Edit > Properties.Result: A Warning prompts
you to save an internal backup copy.
11.4. Click Yes to create a backup, or No to not create a backup.
Result: The D20 Device Wizard Basic Settings window appears.
11.5. Click Next until the Processor tab appears.
11.6. Click the Processor tab > General sub-tab.
11.7. From the Part Number field, click Select.
Result: The Select a Processor Card window appears.
11.8. Select one of the three D20MX processor type part numbers (526-3001, 526-
3003 or 526-3005).
11.9. Click Next, Next, Firmware tab, Select.
11.10. Select either SAN0001 / 000 or SAN0002 / 000. If you had opted to upgrade the
firmware in ConfigPro, then this step is not necessary.
11.11. Click OK.
11.12. Click Next, Finish.
Result: The D20 Device Wizard closes.
12. Review warnings:
12.1. Click the Project tab of the original D20 device configuration.
12.2. Click the D20 device.
12.3. Click the ribbon Configure group > Draw > select Output Window.
Result: The Device Log window appears.
12.4. Review all warnings and make corrections as needed, reviewing the backup
copy to retrieve values that may have been replaced with default values during
the upgrade.
13. Ensure the BOOTP client is disabled:
13.1. Click the Project tab of the original D20 device configuration.
13.2. Click the D20 device.
13.3. Click the ribbon Edit group > Properties.
Result: A Warning prompts you to save an internal backup copy.
13.4. Click Yes to create a backup, or No to not create a backup.
Result: The D20 Device Wizard appears.
13.5. Click Next until the Processor tab appears.
13.6. Click the LAN Settings tab > General sub-tab.
13.7. From the BOOTP Settings frame, ensure Not Used is checked.
13.8. Click Next and Finish.
Result: The D20 Device Wizard closes.
14. Disable new applications not in the transferred D20/D200 firmware:
14.1. Click the Project tab of the original D20 device configuration.
14.2. Double-click the D20 device.
Result: The Application List popup appears.
14.3. Control click on applications not in the transferred D20/D200 firmware.
Result: The application rows are highlighted.
GENERAL 71