GE D20MX User Manual page 73

CHAPTER 5: CONFIGURING THE SOFTWARE
D20MX HARDWARE USER'S MANUAL
16.6. Click OK.
Result: The Browse For Folder dialog appears.
16.7. Browse for the folder containing the exported IP Redundancy Monitor point
descriptions and click OK.
Result: The Point Descriptors dialog appears.
16.8. Confirm the point descriptors are as shown in the following figure.
16.9. Click OK and OK.
Result: The main project window appears.
17. If the site is not using a modem attached to COM0, change the baud rate of COM0 to
19.2K:
17.1. Click the Project tab of the original D20 device configuration.
17.2. Double-click the D20 device.
Result: The Application List popup appears.
17.3. Double-click the WESMAINT II+ application.
Result: The WESMAINT II+ table icon set appears.
17.4. Double-click the Port Configuration table icon.
Result: The Port Configuration table editor appears.
17.5. Change the Baud Rate of COM0 to 19.2k and click OK
Result: The WESMAINT II+ table editor closes.
18. Optionally, update the RADIUS and SYSLOG settings in B014-1N (WESMAINT II+):
18.1. Click the Project tab of the original D20 device configuration.
18.2. Double-click the D20 device.
Result: The Application List popup appears.
18.3. Double-click the WESMAINT II+ application.
Result: The WESMAINT II+ table icon set appears.
18.4. Update the new tables: Remote RADIUS Servers Table, Remote Syslog Servers
Table, TLS Auth Info Table, TLS CA Info Table, First PEM File Table, Second PEM
File Table and Login Warning Banner Table, referring to the B014-1NCG
WESMAINT II+ configuration guide.
19. Generate the iSCS Configuration for the Project:
19.1. Click the Project tab of the original D20 device configuration.
GENERAL 73