Brother ADS-1100W User Manual page 129

Scan from the Control Panel of the Machine
for this setting is port 21. In most cases these two settings can remain as the default (the example below uses
ADS-1600W).
a
(ADS-1600W only)
Choose FTP in Scan to FTP/Network from the Scan tab. Click Submit.
b
Choose the Profile you want to configure in Scan to FTP Profile (for ADS-1100W) or Scan to
FTP/Network Profile (for ADS-1600W) from the Scan tab.
c
Enter the name that you want to use for the profile of the FTP server. This name will be displayed in
Destination in Scan to Network Device from the Scan tab (ADS-1100W only) or on the LCD of the
machine (ADS-1600W only), and can be up to 15 characters.
d
The Host Address is the domain name of the FTP server. Enter the Host Address (for example
ftp.example.com) (up to 64 characters) or the IP address (for example 192.23.56.189).
e
Enter the Username that has been registered with the FTP server for the machine (up to 32 characters).
f
Enter the Password for access to the FTP server (up to 32 characters).
g
Enter the destination folder where your document will be stored on the FTP server (for example
brother\abc) (up to 60 characters).
h
Choose the file name you want to use for the scanned document. You can choose from seven preset
and two user defined file names. The file name that will be used for your document will be the file name
you selected plus the last 6 digits of the scanner counter plus the file extension (for example,
Estimate_098765.pdf).
4
117