Overdubbing A Performance Recording; Deleting A Specific Part/Track - Casio CTK-8IOin User Manual

Overdubbing a Performance
Recording
You can use the following procedure to record a melody in
Track 2 so it combines with a recording you previously made
in Track 1.
1
Press the RHYTHM button to enter the rhythm
mode.
Indicator
appears
2
Use the RECORDER button to select record standby.
3
Press the RIGHT/TRACK 2 button to select Track 2
as the recording track.
4
Select the tone you want to use.
5
Press the controller block START/STOP button.
• This starts playback of Track 1 and recording in
Track 2.
6
Play the melody notes you want as you listen to
the playback from Track 1.
7
To stop recording, press the controller block START/
STOP button again.
• If you make a mistake, you need to go back and re-
record from step 2.
• If you want to immediately hear what you recorded,
press the controller block START/STOP button again.
NOTE
• Track 2 is a melody-only track, which means that chord
accompaniment cannot be recorded there. Because of
this, the entire range of the keyboard becomes a melody
keyboard when recording the Track 2, regardless of the
current MODE switch setting.
• If you want to record without playback from a recorded
track, enter playback standby, deselect the playback
track, and then enter record standby. Note, however,
that you cannot turn off rhythm and Auto
Accompaniment.
CTK810IN_e_36-41.p65
Flashing
41
Recording and Play Back
Track 2 Data
In addition to notes played on the keyboard, the following
data is also recorded to Track 2.
• Tone number
• Pedal operations
• PITCH BEND Wheel operations

Deleting a Specific Part/Track

You can use the following procedure to delete a specific
part/track from a lesson recording or performance recording.
Getting Ready
I When deleting a lesson recording part
• Press the SONG BANK button.
I When deleting a performance recording track
• Press the RHYTHM button.
1
Press the RECORDER button to enter record
standby.
2
Select the part/track you want to delete by pressing
the LEFT/TRACK 1 button or RIGHT/TRACK 2
button.
3
Hold down the RECORDER button.
• This causes a confirmation message to appear on the
display.
• To cancel the delete operation, press the [–] (NO)
button .
4
Press the [+] (YES) button to delete the part/track.
• This causes the keyboard to return to playback
standby.
NOTE
• Pressing the RECORDER button while the part/track
delete screen is on the display returns to record standby.
07.4.10, 3:47 PM
E-41