Part/Track Indicators in Playback
Each press of a part/track button toggles playback of that
track on (part/track indicator displayed) and off (indicator
Example: The above indicates that Track 1 will be played back,
while Track 2 will not.
Part/Track Indicators in Recording
The part/track indicator will be displayed if its track already
Press the part/track button of the track to which you want to
record (record track). This causes its part/track indicator to
flash. The part/track indicator of the other track will remain
displayed (without flashing) to indicate that it will playback
during recording (playback track).
Example: The above indicates Track 1 is the playback track,
and Track 2 is the record track.
Recording and Play Back
To record your keyboard
• Recording to a track that already contains data causes
the existing data to be replaced by your new
Press the RHYTHM button to enter the rhythm
Use the RECORDER button to select record standby.
• This causes the RECORDER indicator to flash on the
Press the LEFT/TRACK 1 button to select Track 1.
• This causes the L indicator to flash, indicating that
Track 1 is the recording track.
Configure the following settings as required.
• Tone (page E-17)
• Rhythm (page E-28)
• MODE switch setting (page E-29)
• Use a slower tempo if you feel you might have trouble
playing properly at a faster tempo (page E-21).
Press the controller block START/STOP button.
• This starts recording.
Play the notes you want on the keyboard.
• Besides notes, any chords you play on the keyboard
are recorded, along with their Auto Accompaniment
patterns. Melody notes you play are also recorded.
• Any pedal operations you perform while playing are
To stop recording, press the controller block START/
STOP button again.
• If you make a mistake, you need to go back and re-
record from step 2.
• If you want to immediately hear what you recorded,
press the controller block START/STOP button again.
07.4.10, 3:47 PM