6.0 Day To Day Operations; Standard Operations; Normal Arming - Bosch DS7400XiV4-EXP User Manual

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations

6.0 Day to Day Operations

6.1

Standard Operations

This section describes the standard (those built and programmed into your system at the factory) procedures for
arming and disarming your security system. Your installing company can program your system for various
optional operations (refer to Section 6.2 Optional Operations).
6.1.1

Normal Arming

Normal arming is used when no one is left on the premises, all zones must be armed, and an entry/exit delay is in
effect. The green Status LED must be lit and, if using a text keypad, "Ready to Arm" must be displayed. If the
green LED is not on or the keypad displays "Not Ready," you must use other methods to arm the system (refer to
Section 6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).
Table 3: Normal Arming
Equipment Command Sequence
Text Keypad [PIN][On]
LED
Keypad
RF3341 [PIN][#][1]
Keypad
RF3332 Press ARM button
RF3334
* Text Keypad only
Bosch Security Systems | 6/05 | 4998154961B
What Happens
• The red Armed LED flashes.
• "Armed" is displayed. *
• "Exit Now" is displayed during the exit-delay
period. *
• A single beep sounds.
• The red Armed LED lights steady when the
exit-delay period ends.
• All zones are armed.
• The LED flashes indicating a signal was
sent to your security system.
• All zones are armed.
All zones are armed.
EN | 7
What To Do
Exit during the exit-delay period.
Exit during the exit-delay period.
Exit during the exit-delay period.