Normal Disarming - Bosch DS7400XiV4-EXP User Manual

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations
6.1.6

Normal Disarming

Please read Section 7.0 Emergency Procedures on page 19 before you are confronted with an emergency event. If you
entered the building through a perimeter door, you might hear a steady entry alert tone from the wired keypads.
If so, disarm according to the chart below.
If an alarm occurred sometime before your arrival, one or more of these happens:
• The bells and sirens sound.
• The wired keypads issue a pulsed tone during the entry delay instead of the usual steady tone.
• The red Armed LED on any LED keypad flashes.
• The red Armed LED on any text keypad flashes and "Zone Alarm" is displayed.
If the alarm is not yet investigated, do not enter the building unless accompanied by the appropriate
Emergency Services' personnel.
Table 8: Normal Disarming
Equipment
Text Keypad LED
Keypad
RF3341 Keypad
RF3332/RF3332E
RF3334/RF3334E
* Text Keypad only
Bosch Security Systems | 6/05 | 4998154961B
Command Sequence What Happens
[PIN][Off] •
•
•
•
•
[PIN][#] •
•
•
Press DISARM •
(unlock) button
•
•
Note: When in Commercial Fire Mode, enter [PIN][#] a second time on a text or LED keypad to
locate the fire zone number(s) in alarm.
The red Armed LED turns off.
All sounders are silenced.
All zones are disarmed.
A single beep sounds.
If a fire alarm was sounding,
"Sounder Silenced" is displayed until
the system is reset. *
The LED flashes indicating a signal
was sent to your security system.
All sounders are silenced.
All zones are disarmed.
The LED flashes indicating a signal
was sent to your security system.
All sounders are silenced.
All zones are disarmed.
EN | 12
What To Do
• Determine why the sounders, if
any, were activated.
• Correct the cause.
• If a fire alarm was sounding,
correct the cause and press
[System Reset] or [#][4][7] to
reset the system.
• Determine why the sounders, if
any, were activated.
• Correct the cause.
• If a fire alarm was sounding,
correct the cause and press
[System Reset] or [#][4][7] to
reset the system.
• Determine why the sounders, if
any, were activated.
• Correct the cause.
• If a fire alarm was sounding,
correct the cause and press
[System Reset] or [#][4][7] to
reset the system.