Custom Arming - Bosch DS7400XiV4-EXP User Manual

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations
6.1.4

Custom Arming

Custom arming is used to arm zones that you specify and your installer programs into your system. An entry/exit
delay is in effect unless otherwise programmed.
The green Status LED must be lit and, if using a text keypad, "Ready to Arm" must be displayed. If the green
LED is not on or the keypad displays "Not Ready," you must use other methods to arm the system (refer to Section
6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).
Table 6: Custom Arming
Equipment
Text Keypad LED
Keypad
RF3341 Keypad
RF3332/RF3332E,
RF3334/RF3334E
* Text Keypad only
Bosch Security Systems | 6/05 | 4998154961B
Command Sequence What Happens
[PIN][#][4] •
•
•
•
•
•
•
[PIN][#][4] •
•
The red Armed LED flashes.
"On Partial" is displayed. *
"Exit Now" is displayed during the exit-
delay period. *
The green Status LED lights steady.
A single beep sounds.
The red Armed LED lights steady when
the exit-delay period ends.
The zones that were programmed for
custom arming are armed.
The LED flashes indicating a signal was
sent to your security system.
The zones programmed for custom
arming are armed.
Not applicable
EN | 10
What To Do
Exit during the exit-delay
period.
Exit during the exit-delay
period.