6.2.10 Changing The Date; 6.2.11 Setting The System Clock - Bosch DS7400XiV4-EXP User Manual

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations

6.2.10 Changing the Date

Because you can change the system date only in Master Programming Mode, you cannot program the system
date from an RF (wireless) keypad.
Record your entries so they are available before you enter Master Programming Mode. Enter the
parameters promptly. If a delay of 15 seconds or more occurs between your entries, the 3-beep error
tone sounds and the control panel automatically exits from the programming mode.
Table 18: Changing the Date
Steps To Change the Date
Enter Master Programming Mode.
Enter 2 for System Date Setup
programming.
Enter the Month.
Enter the Day.
Enter the Year.
Note: Entering the command sequence [Master Code][#][0][2][#] causes the text keypad to display the date.

6.2.11 Setting the System Clock

Because you can only set the time on the system clock in Master Programming Mode, you cannot program the
system clock from an RF (wireless) keypad.
Record your entries so they are available before you enter Master Programming Mode. Enter the
parameters promptly. If a delay of 15 seconds or more occurs between entries, the 3-beep error tone
sounds and the control panel automatically exits from the programming mode.
Do this procedure at a text keypad because no visual clues are provided from an LED keypad.
Table 19: Setting the System Clock
Steps To Set the Time
Enter Master Programming Mode.
Enter 6 for System Date Setup
programming.
Enter the Day.
Enter the Time.
Enter AM or PM.
* This is displayed only in Single Partition Mode
Bosch Security Systems | 6/05 | 4998154961B
Command Sequence
[Master PIN][#][0]
[2]
[0][1] through [1][2]
[0][1] through [3][1]
Last two digits of the year
followed by [#].
Command Sequence
[Master PIN][#][0]
[6]
[1] through [7]
Sunday Saturday
[0][1][0][0] through
[1][2][5][9]
[4][#] for AM or
[6][#] for PM
Note: Entering the command sequence [Master Code][#][0][2][#]
causes the text keypad to display the date.
If Accepted, the Text Keypad Displays:
"2 Change Date"
(display scrolls to this)
"Enter Month"
(01 ... 12)
"Enter Day"
(01 ... 31)
"Enter Year"
(XX) End with #
"Month, Day, Year"
A long beep signifies acceptance.
If Accepted, the Text Keypad Displays:
"6 Change Time" *
(display scrolls to this)
"Enter Day"
(1 ... 7)
"Enter Time"
(0100 ... 1259)
"Enter AM/PM"
(4/6) End with #
"Day – Time"
A long beep signifies acceptance.
EN | 18