Chime Mode; Access Control - Bosch DS7400XiV4-EXP User Manual

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations
6.2.8

Chime Mode

Chime Mode causes the keypad sounders to beep each time a Perimeter or Entry/Exit zone is triggered when the
control panel is off (disarmed). The [#][7] command is used to turn Chime Mode both off and on.
Table 16: Chime Mode
Action Equipment
Turn On Text keypad
Chime Mode LED keypad
RF3341 keypad
Turn Off Text keypad
Chime Mode LED keypad
RF3341 keypad
* Text Keypad only
6.2.9

Access Control

Your system might use a keypad key sequence to activate other electrical devices. Access control is not available
from an RF (wireless) keypad or from the keyfobs. Refer to Access Code on page 24.
This feature can be used in armed or disarmed modes.
The special PIN required to perform this function is known as an Access Control PIN. This PIN can control
devices that are activated for a short period of time (for example, electric locking mechanisms on a door). Access
PIN activations are recorded in the History Buffer.
Table 17: Access Control
Type of Disarming
Momentary Access Control Panel Activation
Bosch Security Systems | 6/05 | 4998154961B
Command Sequence What Happens
[PIN][#][7] •
•
•
[PIN][#][7] •
•
•
Command Sequence
[Access Control PIN][Off]
"Chime Mode On" is displayed for 5 seconds. *
The LED flashes indicating a signal was sent to your security
system. **
Keypad sounders beep for 2 seconds whenever a Perimeter
or Entry/Exit zone is triggered.
"Chime Mode Off" displays for 5 seconds. *
The LED flashes indicating a signal was sent to your security
system. **
Chime Mode is turned off.
** LED Keypad only
What Happens
The access device is activated for 10 seconds.
EN | 17