Reset Sensors ? (Command + 4 + 7); Reset Sensors; Using Reset Sensors - Bosch Security System User Manual

Security System | User's Guide | Part II: System Commands - RESET SENSORS ? (COMMAND + 4 + 7)

RESET SENSORS ? (COMMAND + 4 + 7)

Reset Sensors

Description
Detection devices, such as smoke detectors and shock sensors,
must be reset after being activated. This function momentarily
removes power from these sensors to reset them.
COMMAND 47 also clears
point information from the
display, leaving the *Alarm
Silenced* message
in the display as a reminder that the View Memory function
can be used to view the cleared point information.

Using Reset Sensors

1. Ensure your keypad shows idle
disarmed text.
Bosch Security Systems | 9/04 | 4998122475D
2. Press the COMMAND
3. The display shows *System
Command*.
4. Press the 4 key, followed by the
7
key.
If you prefer, you may use the Command Menu in
place of steps 2 and 3 to initiate this function.
Press the Menu> key to enter the Command
Menu, then press Next> repeatedly until you
reach the RESET SENSORS ?> prompt. Press
the RESET SENSORS ?> soft key.
key.
+
49