Bosch Security System User Manual page 17

The system will now display *Alarm Silenced* ... and then
the number of points in alarm (# FIRE ALARMS) and then
the area text appears (AREA 1 NAME TEXT) followed by
the custom text of all the points in alarm (SMOKE
DETECTOR), in the order of occurrence.
If there is more than one point causing an alarm, the display
will show each point for three seconds before showing the
next one.
When the last alarm is shown, the next display is the first
alarm.
Your system may be programmed so that you cannot silence
some fire alarms until the fire event clears. Entering
COMMAND 4 clears the scrolling point text from the display.
The *Alarm Silenced* message will continue to alternate
with idle text as a reminder that it is still possible to view the
text of the points in alarm by using the View Memory
function (refer to VIEW MEMORY ? (COMMAND + 4 + 0) on
page 43) for more information.
Bosch Security Systems | 9/04 | 4998122475D
Security System | User's Guide | Part I: Security System Basics - Fire Alarms
To clear the event memory and remove the *Alarm
Silenced* message from the display, press the Clear
Display> soft key.
The display will show the instructions for clearing the
message. Enter a valid passcode and press the Clear> soft
key.
If a fire trouble still exists, the display shows Fire Trouble. To
remove this display, the fire point(s) must be returned to
normal.
If you have not cleared the *Alarm Silenced* display and
wish to review cleared events, use COMMAND 40.
17